jonc
22nd November 2008, 08:22
having a little problem flashing my benq am following the texbook guide to flash with iprep ad a usb pen. on the part where it says press y to resend to vender it say you need to turn the 360 on and staus toggles between 0x51 0xD1 then turn 360 off wait a few seconds status stays at 0xD1 then turn on 360 then you get 0x73 and it will start to read the firmware but i only have to turn it on once and it comes up 0x73 and starts reading it right away. it make aback but i dont wat to flash it incase i cock it up with it only doing it once